QVS Training Part

This is the QVS training part, used for the presentation and training classes. In order to run a stored part program, the part needs to be "located" as it was originally programmed, but not necessarily in the same spot. A setup screen prompts the operator to position the lower left hole "under" the Circle target and press X-Y to set zero. Focus on the top surface to set Z to zero. Joystick the lower right hole and use the align button, to set the X-axis alignment. Press Ok and the part program will run automatically.

Measure-X Training video
Click the thumbnail to see a stored part program in action.

Part location for program Run
Use the Target-Circle function, position the overlay over the lower left hole and press X-Y to set datum to 0,0.

Focus function
Select a high magnification, and use the AutoFocus function to detect a Z point and press Z to set Z datum to 0.

Skew alignment
Use the Target-Circle function and position the overlay over the lower right hole and press Align, for the new X axis.

Feature Finder - Circle
Pick three points on a circle, for a automatic circle measurement.

Feature Finder - Arc
Pick three points of an arc, for a automatic arc measurement.

Edge Trace
Start point, direction and end point to trace the entire perimeter of a part.

Feature Finder - Line
Click and drag mouse along edge for a automatic line measurement.

Copy Function - Lines
Use multiple "lines" to construct other features, ie: slots.

Model Window
Use existing features to construct other types of features (slots, circles, intersections, datums, etc.).

Simple listing
Short format of program steps.

Expanded program listing
Detailed listing of program format and features.